Smart set dial is not working.
Cricut print and cut calibration not working.
So by the time you have got here you might have already followed the troubleshooting advice on the cricut page and the many tutorials help videos from cricut and other third party lovelies on youtube etc.
My mat is crooked when loaded into my cricut machine.
In the cricut design space select a print then cut image and click go if this is your first time using print then cut it will prompt you to calibrate.
The next screen shows a preview of the calibration sheet.
Cricut machine roller bars are not moving.
I thought the cricut was just cutting too high and too far to the left but i noticed that s not the case.
Cut sensor light does not turn on during print then cut.
If you are using a piece of loose glitter cardstock mirror your image and turn over the paper.
Be sure that you actually have the image set to cut and not print or write.
My explore machine pauses or stops when cutting writing or scoring my project.
Select print then cut calibration the print then cut calibration window will appear.
Print and cut should only be used with white materials otherwise your blade may not read the cut sensor marks correctly.
I tried to just avoid print then cut after a while but those attempts were a worse outcome.
Print the calibration sheet provided by the software.
You have probably come here because you have cricut calibration problems sensors are not reading cut marks.
The goal of print then cut calibration is for your cricut to precisely cut around the edge of the printed image like you see above.
Basically during the calibration process i noticed that the larger box never cuts properly.
Tap print sheet in the bottom right of the screen.
If your printer is not already selected tap select printer.
Always test cut prior to starting so you can find out sooner than later.
The machine will cut a series of lines and ask the user a series of questions that will allow the machine to calibrate the best settings for the print then cut.
Print then cut calibration within cricut design space there is a print then cut calibration this will allow you to print a test page and then cut it with the cricut machine.
The first step is to print out the calibration sheet on your home printer.
Having the same problem.
This allows the machine to cut without the glitter getting stuck on the blade and in the housing.
Firmware update cricut explore and maker machines.
